Vibration isolation is an important part of the physical autopilot installation. We have found that wire rope isolators work well for this purpose.
Our uLRC (microLRC) kit even comes with 3 wire rope isolators and an L-bracket mounting kit.
The wire r
Hi guy
Now I have MP2128g2 use for my Fix wings but, I have plan to make Drone for Inspection
I have a question
1. Can I use MP2128heli to replace the DJI board in the M600 model?
2. In the auto flight Can fly to set WPT vertically?
3. Is there any pl
Hello everybody!
Looking inside Horizon's installation folder I can see a set of four .bin files (normal, FL, heli, heli3x) containing "G2" in the name, and an identical set with "G2x". I cannot find on the manual an explanation about these. Can some
Read more…Hi
Everyone.
I applied a power of 12.4V to my MP2028.
However, the LED did not turn on. And I checked the power input of the sensor installed on each board, but the power does not come on normally.
I checked that the wiring was OK and checked that P
Read more…Support for a secondary COM port was added to the autopilot recently. This is a port that always existed on G2 hardware but was not enabled in the software until now.
You will see the terms COM2 and RADB used in this post and within Horizon/VRS setti
Read more…Hello, I have questions regarding the GPS transition cable attached on the MP board.
What type of cable does it use? What is the Hirose / Digikey part number for the MCX and H.FL connector on it?
Thanks in advance.
Read more…Hi everyone,
I have some questions about micropilot.
I used MP2128LRC2 Heli Autopilot 900 MHz, and Tarot 650 as the vehicle.
We chose Quadrotor A as our mode.
My questions are:
1. Is it normal for all the motor to turn on briefly everytime we click the
We have been sponsored a cm100 gimbal from uav vision (awesome gimbal, thanks guys!) however we can't communicate with it (not the gimbal's fault). Has anyone used tpu lines out of the servo board before? We have to use a TTL-RS232 converter as it is
Read more…I am trying to move my MP to a larger air frame and would like to know if anyone has any files for doing this? I have had this system for 5yrs and after I didnt get any where with MP I just gave up but I would like to see something out of my 12k inve
Read more…
